Product Catalog
Pipe and Tube Punching and Notching
Project Tool & Die specializes in punching, notching, cutting, and mitering of pipe and tube. Their tools can work with almost any press or ironworker. Their piercing units can have a mandrel or be open.
The Linders Abrasive Belt Coper, sometimes called a pipe notcher or tube notcher, uses an abrasive belt driven by a powerful five horsepower electric motor to cope, or notch, a work piece to fit a pipe or round tube. An insulated foot switch activates the motor while the work piece is held in the fully adjustable vise and is fed by pulling on a lever. By using interchangeable rollers, or spindles, diameters from ¾ inches to eight inches may be coped on the end of a part. The angle of the cope is easily adjustable with a clamping knob. Notching or coping pipe and tube to precise angles doesn't get any better than this!
By using the most powerful motor available on an abrasive coping machine, and running it only while a cope is being made, low noise exposure levels and long life are assured. Available in 220 volt, single phase and 230/460 volt, three phase, the Coper is ready for any shop.
Linders Abrasive Belt Coper
P.O. Box • Nyack, New York 10960-0831
Phone: (845) 353-1395 • Fax: (845) 353-1087
or Email Us at mail@nyrock.net